Filter
Top Products
I.........,......
To
activate an extension as a paired telephd&$f& console 1
AB=[rin :
extension (Jack number 01)
n’E[
:
extension (Jack number 32)
To
activate an extension as a paired telephone
for console 2
CD= mm : extension
(Jack number 01)
m.121: extension (Jack number 02) default ......
lTiE[ : extension
(Jack number 32)
L7D~Ir~~l3nEl
04 NEXT NEXT A6 MEMORY NEXT CD MEMORY END
Description
The extension number paired with the DSS
Console (KX-T123240) must be assigned when
the DSS Console is used. The jack number of the
extension phone is programmed to identify the
paired phone. Up to two DSS Consoles can be
used for each 32 extension phones.
When all incoming calls on outside lines are set
(using “CO Mode Assignment” on page 3-57) t0
ring at the operator extension phone, assigning
the DSS Console to the operator extension will
make the operator’s job much easier.
Programming
1.
Dial (04)
“DSS Assign”will be displayed.
2. Press the NEXT button.
“DSS NO ? + ” will be displayed.
3. Press the NEXT button.
“DSS 1 : Jack - 01” will be displayed and
“01” will blink.
4. Dial the jack number which is paired with
the consolel.
5. Press the MEMORY button.
The LCD will stop blinking.
0 If console 2 is not connected, proceed to
step 9.
6. Press the NEXT button.
“DSS 2 : Jack - 02” will be displayed and
“02”will blink.
3-10
7. Dial the jack number which is paired with
the console 2.
8. Press the MEMORY button.
The LCD will stop blinking.
9. To return to the initial program mode, press
the END button.
Conditions
0
Up to two DSS consoles can be connected.
l
The DSS console can not be connected in
pair with a standard telephone.
l
Two DSS consoles can’t be entered to one
jack number.
Example
:
If Mr Jay’s secretary has KX-T123230 at
extension jack number 10 and it is to use the
DSS console (KX-Tl23240), the console should
be connected to the modular jack!marked MJl)
of the DSS card (KX-T123241).
(Paired extension is jack number 10.)
If Mr Brown’s secretary has KX-T123220 at
extension jack number 20 and it is to use the
DSS console (KX-T123240), the console should
be connected to the modular jack (marked MJ2)
of the DSS card (KX-T123241).
(Paired extension is jack number 20.)
Programming Table
See page 7-3.