Filter
Top Products
:..............,........until the desired CO number (01 through 12) appears
I”“““““““““““““““” C= dial the trunk group number (1 through 8)
I
~INEXT*h~(IENDI
;m$akl
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
q
: trunk group number 1
q
: trunk group number 8 _- _
efault
CO 01 is assigned to Trunk group 1.
CO’07 is assigned to Trunk group 7
CO 08,09, 10,ll and 12 are assigned to Trunk group 8.
AB=
El
:
to assign the same on all 12 CO’s
mlil :onCOOl
mm :onCO 12 D
Description
When outside lines are grouped, an idle line
within the trunk group is automatically found and
connected when an outside call is placed.
A maximum 8 groups can be assigned.
For example, if subscribing with multiple
telephone service companies, the CO lines can be
grouped as shown below by each company.
Trunk Group 1
Trunk Group 2
Service Company A
Trunk Group 3
Service Company C
Refer to “Outward Dialing (Individual Trunk Group
Access)” on page 4-3 and “Flexible CO Button (To
Assign into Trunk Group Access Button)” on page
4-57.
2. Press the NEXT button.
“CO NO ? +” will be displayed.
3. Press the NEXT button or dial the CO number
(01 through 12).
“CO 01: TRK GRP-1” will be displayed and “1”
will blink.
4. Dial the trunk group number (1 through 8).
5. Press the MEMORY button.
The LCD will stop blinking.
6.
l
To advance to the next CO number,
press the NEXT button.
l
To return to the previous CO number,
press the PREV button.
0 To go to the desired CO number,
press the SELECT button and then dial the
CO number.
7. Repeat steps 4 to 6, to program the trunk group
_.
number on the other CO lines.
6. To return to the initial program mode, press the
rrogrammmg
1.
Dial (44).
“Trunk Group” will be displayed.
END button.
Programming Table
See page 7-13.
3-52