Filter
Top Products
i................until the desired extension group number (1 through 8) appears.
;” until the desired hunting type appears
;
; [
Terminate : searching for larger jack numbers upward ..... default-(all 8 groups)
Circular
: circular searching for other numbers
A=m : to assign the same of all 8 extension groups
~.,.............................~
Discription
Specifies the order in which idle extensions
are searched when “Call Hunting” is used.
The “Terminate Mode” searches for idle
extensions with a higher order extension than
the jack number of the dialed extension, and
terminates when the search reaches the
highest jack number of extension in the same
group. If all higher order numbers are busy, a
busy tone will be heard.
The “Circular Mode” searches for any idle
extension in the same group.
If all extensions are busy, a busy tone will be
heard.
The “Setting (Call Hunting)” on page 3-l 5 must
be set to “Enable” mode for Hunting Type to
be used.
Programming
1.
Dial (09).
“Hunting Type” will be displayed.
2. Press the NEXT button.
“Group NO ?+” will be
displayed.
3.
4.
5.
6.
Press the NEXT button or dial the extension
group number (1 through 8).
“Group 1 : Terminate” will be displayed and
“Terminate” will blink.
Press the SELECT button to alternate
between “Terminate” and “Circular”.
Press the MEMORY button.
The LCD will stop blinking.
To advance to the next extension group
number, press the NEXT button.
To return to the previous extension group
number, press the PREV button.
To go to the desired extension group
number, press the SELECT button and then
dial the extension group number.
7. Repeat steps 4 to 6, to program the
hunting Type of the other groups.
8. To return to the initial program mode,
press the END button.
Programming Table
See page 7-4.
3-16