i............“....‘.....-until the desired extension group number (1 through 8) appears
_..................................
until the desired mode appears
Disable : to disable “Hunting’:.--....default
Enable : to enable “Hunting”
(all 8 groups)
A=B : to assign the same of all 8 extension groups
: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Description
Enables programming to automatically locate
an idle extension within the same extension
group as the dialed extension when the
dialed extension number is busy.
Call Hunting is set by group units. “Extension
Group Assignment” (on page 3-66) is used to
specify which extensions belong to each
group.
Programming
Dial (08).
“Hunting Group” will be displayed.
Press the NEXT button.
“Group NO ? --) ” will be displayed.
1.
2.
3.
4.
Press the NEXT button or dial the extension
group number ( 1 through 8 ).
“Group 1 : Disable” will he displayed and
“Disable” will blink.
Press the SELECT button to alternate between
“Disable” and “Enable”.
5. Press the MEMORY button.
The LCD will stop blinking.
6.
l
To advance to the next extension group
number, press the NEXT button.
l
To return to the previous extension group
number, press the PREV button.
l
To go to the desired extension group
number, press the SELECT button and then
dial the extension group number.
7. Repeat steps 4 to 6, to program the assignment
of the other hunting groups.
8. To return to the initial program mode,
press the END button.
‘-
Conditions
o
When you dial “4 instead of pressing the
NEXT button at step 3, in case all of 8 groups
have been programmed to “Disable”,
“Group */: Disable” will be displayed.
In case each of 8 groups has been programmed
either “Disable” or “Enable”,
“Group x’: Mixed” will be displayed.
_’
Programming Table
See page 7-4.
3-15