Filter
Top Products
:...............- ............ until the desired jack number (01 through 32) appears
i.. ........................... until the desired mode appears
Disable .......... ..default(al I 32 jack numbers)
Enable
I
:
: to assign the same on all 32.jack numbers
Description
This feature can call to the extension that is setting
the Do Not Disturb by programming.
Refer to “Do Not Disturb Override” on page 4-32.
7. Repeat steps 4 to 6, to program the
assignment of the other jack numbers.
Programming
Dial (68).
“DND Override” will be displayed.
1.
2.
Press the NEXT button.
3.
“Jack NO ? + ” will be displayed.
Press the NEXT button or dial the jack
number (01 through 32 ).
“SO1 : Disable” will be displayed and “Disable”
x
jack number
will blink.
4.
Press the SELECT button to alternate
between “Enable” and “Disable” to select the
desired mode.
5.
Press the MEMORY button.
The LCD will stop blinking.
6.
l
To advance to the next jack number,
press the NEXT button.
l
To return to the previous jack number,
press the PREV button.
l
To go to the desired jack number,
press the SELECT button and then dial the
jack number.
6. To return to the initial program mode,
press the END button.
Conditions
This feature allows you to ring an extension that is
set for the “Do Not Disturb” mode.
Programming Table
See page 7-28.
3-75