Filter
Top Products
:..........,..................
. . . . .
until the desired CO number (01 through 12) appears
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
AB=
q q
:
Disable
q
m: r
under 5m seconds :
:.
14 Is] : 62m seconds
m 17]:70
:
. default (all 12 CO’s)
&m :6,4
See the CPC Signal Detect Time table
I
:. ............ until the desired detect time appears
i ...................................
El
: to assign the same on all 12 CO’s
q
1m:onCO12
Description
To detect that an outside party has hung up and
then terminated the outside line (after a
conversation, conference etc.) a CPC signal is
needed. CPC signal detection time can be
removed or changed at customer’s request.
Programming
1.
2.
3.
4.
Dial (55).
“CPC Detection” will be displayed.
Press the NEXT button.
“CO NO?
-.‘I
will be displayed.
Press the NEXT button or dial the CO number
(01 through 12).
“CO 01 : N=42” will be displayed and “42”
will blink.
Dial the CPC Signal Detect Time number (00,
01, 06 through 75).
5. Press the MEMORY button.
Thn I c?n bill dnn hlinkinn
I I IU LVY ““111 vrup “ill 11\11 ‘3.
6. 0 To advance to the next CO number, press
the NEXT button.
l
To return to the previous CO number, press
the PREV button.
l
To go to the desired CO nu:mber, press the
SELECT button and then dial the CO
number.
7. Repeat steps 4 to 6, to program the detect
time of the other CO number.
8. To return to the initial program mode, press the
END button.
~“--I---:-_ T-L,,
rruyrarrlrrllrly
IdUlt:
.
See page 7-23.
Conditions
0 CPC Signal Detect Time number 02 through
05 can not be used.