Filter
Top Products
:..................,until the desired Jack number (01 through 32) appears
i
CDE=~1~1~~ :
to assign phone number 100
mmki : to assign phone number 199~
,...............................
.
pzjliiEq
NEiT IlCtrEll
MEMORY
lpiiq
.
4 I
riiEdsE&m
default
is assigned to extension of Jack number 01
132 is assigned to extension of Jack number 32
I............................................
I
AB=mo[ :
to assign to Jack number 01
I*[ : to assign to Jack number 32
Description
Enables programming of a 3 digits extension
number (100 through 199) for each extension
phone. This provides the freedom to develop a
logical extension numbering system by
department or by building floor as desired.
7. Repeat steps 4 to 6, to program the extension
number on the other jack number.
8. To return to the initial program mode, press
the END button.
l
The LCD will show the initial program
mode, “SYS-PGM NO ? +“.
Conditions
Programming
1.
Dial (02).
0
“Extension No
Set” will be displayed.
2. Press the NEXT button.
“Jack NO ?+” will be displayed.
3. Press the NEXT button or dial the Jack
number (01 through 32 ).
“Jack 01 : EXTlOl” will be displayed and
“101 “will blink. ’
0
4. Dial the extension number which is set
newly ( 100 throug hl99 ).
l
When dialing (150) the LCD will show
“Jack 01 : EXT150” will be displayed.
l
To erase a wrong entry, press the CLEAR
The extension number that has been already
programmed can not be entered.
In case programmed extension number is the
same as what was previously stored, when the
MEMORY button is pressed, three beeps will
be heard.
When the extension number 125 have been
already assigned to the jack number 25, for
programming to assign the extension number
125 to the jack number 02, after
programming to assign ,the other extension
number (100 through 199) to the jack number
25, program to assign the extension number
125 to the jack number 02.
button.
5. Press the MEMORY button.
8.
l
0
0
Programming Table
See page 7-3.
To advance to the next jack number, press
the NEXT button.
To return to the previous jack number,
press the PREV button.
To go to the desired jack number, press
the SELECT button and then dial the jack
number.
3-8