Filter
Top Products
Operation
From outside of System
0
Make a call
to the line
which is
beforehand
p-yyFAed
Line on the
.
KX-’
Dial tone (First dial tone) will be
heard.
If the Outgoing Message Card is
installed to KX-T123211, outgoing
message will be heard instead of dial
tone. (refer to page 2-21)
3211.
.
To call to Extension
n
If Security Type is set to None Security or
Trunk Security.
Dial extension number
(100 through 199)
n
If Security Type is set to All Security.
@J..
.
.
I
. . . . . .
\
Dial user
You will hear
security code
second dial
(60000 through tone
69999)
Dial extension
number (100
through 199)
. To call to CO line
n
If Security Type is set to None Security.
Dial “8” Dial trunk
9
roup number
You will hear D$&ne
CO dial tone
1 through 8)
0
You may-dial automatic line access
number “9” instead of “8” and trunk
group number.
n
If Security Type is set to Trunk Security
or All Security.
Dial user Dial “8”
tEzrity
(60000 through
69999)
Dial trunk You will hear Dial phone
group
CO dial tone number
number
(1 through 8)
l
You may dial automatic line access
number “9” instead of “8” and trunk
group number.
2- 19
-
I
q
When disconnect CO line after finish CO
to CO calling.
Dial “st”
You will hear
first or
second dial
1
tone
To access the System
Dial ‘I*”
Hang up
(Remote Administration)
Dial remote
security code
(70000 through 79999)
0
Data Terminal equipment display as
follows.
; Welcome to KX-TI 23211 remote administration
ver 2.0 Panasonic CO., LTD
;** Jan.1.1988 12
:
00’
AM **
; The “HLP” displays command informations
; > E1
Please refer to the manual “EVVREMOTE
PROGRAMMING NANUAL”.
Note 0
0
Dial Security Code or Extension number
or CO line access number in 10 seconds
after outgoing message is finished or first,
second dial tone are heard.
If Outgoing Message Card is installed and
outgoing message is not recorded, Direct
Inward System Access (DISA) doesn’t
work.
When operator is registered in System,
call to operator automatically and When
operator is not registered in System, call
to general Extension.
When dial the wrong security code 3
times, the call is disconnected.
It is necessary for security code to be
programmed beforehand.
DISA can receive up to 2 calls and can’t
receive more than 3 calls at the same time.
-
0
s
s