Filter
Top Products
I
Description
You can program which outside line is
connected and which one is not connected.
When an extension automatically selects an
idle outside line, the extension can be
connected to it quickly.
Outside Line Feature
......... until the desired CO number (01 through 12) appears.
until the desired mode appears
Connect
. . ..-......default (all 12 Cd’s)
Not Connect
i. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . /I@=
q
: to assign the same on all 12 CO’s
ml?J :onCOOl
lij~l : on CO 12
1.
7.
Repeat steps 4 to 6, to program the mode
on the other CO lines.
8. To return to the initial program mode,
press the END button.
Programming
Conditions
1.
Dial (40).
“CO Connection” will be displayed.
2. Press the NEXT button.
“CO NO ? +” will be displayed.
3. Press the NEXT button or dial the CO
number (01 through 12).
“CO 01 : Connect” will be displayed and
“Connect” will blink.
0
When you dial “4’ instead of pressing the
NEXT button at step 3, in case all of 12 CO’s
have been programmed to “Connect”,
“CO *: Connect” will be displayed.
In case each of 12 CO’s has been
programmed either “Connect” or “Not
Connect”, “CO *: Mixed” will be displayed.
4. Press the SELECT button, to alternate
between Connect and Not Connect to select
the desired mode.
5. Press the MEMORY button.
The LCD will stop blinking.
8.
l
0
0
To advance to the next CO number,
press the NEXT button.
To return to the previous CO number,
press the PREV button.
To go to the desired CO number,
press the SELECT button and
then dial the CO number.
Example
:
CO
1 and 2 . . . . . . . . . . . . . . . . . . . . Connect
CO
3 . . . . . . . . . . . . . . . . . . . . . . . . Not Connect
1. I40JINEXTJINEXTJJl
2. I~~~
3. WISELECTJliGKFllKJ
Programming Table
See page 7-12.
3-48