Filter
Top Products
:~~~~~~......‘.‘.‘.“‘.- until the desired CO number (01 through 12) appears
n.................................
until the desired flash timing appears
300ms
600ms . . . . .
default (all 12 CO’s) :
900ms
1200ms
onC0 12
Description
The timing of the hookswitch flash signal must
be within the requirements from your Central
Office. There are four choices available 0.3, 0.6,
0.9, or 1.2second.
6.
l
0
0
Programming
1.
Dial (54).
“Flash Time Set” will be displayed.
2. Press the NEXTbutton.
“CO NO ?+” will be displayed.
3. Press the NEXT button or dial the CO number
(01 through 12).
“CO 01 : 600ms” will be displayed and
“600ms” will blink.
4. Repeat pressing the SELECT button until the
desired value is displayed.
5. Press the MEMORY button.
The LCD will stop blinking.
To advance to the next CO number,
press the NEXT button.
To return to the previous CO number,
press the PREV button.
To go to the desired CO number,
press the SELECT button and then dial the
CO number.
7. Repeat steps 4 to 6, to set the hookswitch
timing of the other CO’s.
6. To return to the initial program mode, press
the END button.
Example:
0.3 set on al I 12 CO’s =
.
Programming Table
See page 7-23.
3-61