Filter
Top Products
To connect Amphenol 57JE
type (screw-attach-type 50-pin
connector) to the KX-T123211,
follow the procedure below.
1. Loosen the three screws to move the metal
bar aside.
I
Metal bar
317
Screws
2. Pull the Expansion Card (LC#l)
3.
The 50-pin connector (JACK) on the
Expansion Card has two hook-pins.
Remove the upper hook-pin, taking
out the screw.
/Expansion
Card
,50-pin
connector
4.
To attach the Amphenol 57JE type
(PLUG) to the connector, drive the
accessory Screw at the upper part,
.
and fasten the accessory Wire Tie
around the lower hook-pin and the
Amphenol 57JE type, as shown.
50-pin*
connector
Hook-.pin
Accessary
Wire Tie
When connecting a connector of the type shown
below, unscrew the lower hook-pin, too. Then drive
both accessory Screws.
I
Expansion
Card
5d-pin Aonnector
5.
Replace the Expansion Card (LC#l).
6.
To connect to the other Expansion Card
(LC#2), repeat the steps 2 to 5.
7.
Replace the bar and tighten the screws.
2-9