Filter
Top Products
. . . . . . . . . . . . . . . . . . .
-until the desired CO number (01 through 12) appears
........................
up to 8 outside access codes each with a
....~~~~~~~~ default (all 12 CO’s)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
AB= r;;l
:
to assign the same on all 12 CO’s
ml :onCOOl
&I
1 2 :onCO12
Description
If KX-T123211 is installed behind a host PBX, the
host PBX may require a pause time to access
Central Office Lines. This feature enables the host
PBX to automatically pause via programming the
outward dialing access codes of the host PBX.
Programming
1.
Dial (43).
“HostPBXAccess”wiII be displayed.
2. Press the NEXT button.
“CO NO ?+” will be displayed.
3. Press the NEXTbutton or dial the CO number
(01 through 12).
l
The LCD will show “CO 01 : Not Stored”
when nothing is stored in CO 1.
When the outside access codes 81,82 has
been stored, “CO 01 : 81,82” will be
displayed.
4. Enter up to 8 outward access codes each
with a maximum of 2 digits, punctuating each
code with the “ 1” button.
l
To erase a wrong entry, press the CLEAR
button.
6.
l
To advance to the next CO number,
press the NEXT button.
l
To return to the previous CO number,
press the PREV button.
l
To go to the desired CO number,
press the SELECT button and then dial the
CO number.
7. Repeat steps 4 to 6 to program each of the
r
CO’s of the KX-T123211.
l
8. To return to the initial program mode, press
8
the END button.
F
Example:
E
l
AccessCodes ,82,83,9onCOl
K
1 MEMORY IIENDI
Programming Table
See page 7-12.
5. Press the MEMORY button.
3-51