Filter
Top Products
Description
Programming
Direct Inward System Access (DISA) is the
feature that enables outside line incoming calls to
be directed to an extension phone by designating
it or to an outside line through the KX-Tl23211.
When programmed, the following contents of
DISA can be set up.
n
Control code “ * ”
Sets to ignore the signal of ‘I*” key.
n
Prolong Time
.
Sets duration time of talking past CO-to-CO
Duration Time Limit when dialing out on an
outside line (2, 3, 4 or 5 minutes)
n
Answer Delay Time
Changes the time from receiving a call to
answering it. (0, 5, 10 or 15 seconds)
n
Tone Detect
KX-T123211 is set whether detect that the
call is disconnected after finish having a
conversation on CO line with Tone.
Enable . . . .
detect with Tone.
Disable . . .
don’t detect with Tone.
n
Security Type
Sets to require or not a Security Code when
dialing an extension or outside line.
l
None Security
This is the mode in which Security Code
is unnecessary when dialing both an
extension or outside line.
l
Trunk Security
This is the mode in which Security Code
is necessary when dialing an outside line,
but unnecessary when dialing an
extension.
l
All Security
This is the mode in which Security Code
is neccessary when dialing both extension
and outside line.
n
Remote Security-Code
Remote Security Code is used when
Remote Administration is done with DISA.
n
User Security Code
User Security Code is used when dial to
extension or CO line with DISA.
User Security Code can be set by 4 types.
1.
2.
3.
4.
5.
6.
7.
6.
9.
10.
11.
12.
13.
Dial (31).
c
“DISA Parameters” will be displayed.
Press the NEXT button.
“Control Code “ x “‘I will be displayed.
0 You may repeat pressing the NEXT button
until the desired mode (Control code “3~ “,
Prolong Time, Answer. Delay Time, Tone
Detect, Security Type, Remote Security
Code, User Security Code) is displayed.
Press the SELECT button.
“Code “ *” :
Enable” will be displayed and
“Enable” will blink.
Press the SELECT button to alternate between
“Enable” and “Disable” to select the desired
mode.
Press the MEMORY button.
The LCD will stop blinking.
Press the NEXT button.
“Prolong Time” will be displayed.
Press the SELECT button.
“Prolg Time: 5 min” will be displayed and “5”
will blink.
Repeat pressing the SELECT button until the
desired add time (2, 3, 4 or 5 minutes) is
displayed.
Press the MEMORY button.
The LCD will stop blinking.
Press the NEXT button.
“Ans. Delay Time” will be displayed.
Press the SELECT button.
“Delay Time: 10 set” will be_ displayed and
“10” will blink.
Press the SELECT button until the desired
delay time (0, 5, 10 or 15 seconds) is
displayed.
Press the MEMORY button.
The LCD will stop blinking.
I
3 -
43