Filter
Top Products
\
I
Service Class Selections
\
I
t
Allowed
all calls
Denied
2.
l
toil calls
l
international calls
l
local calls (charged)
l
local calls
3.
l
selected area codes
l
local calls (charged)
l
local calls
l
international calls
l
any calls other than
specific area code
programmed
4.
l
local calls (charged)
l
international calls
l
local calls
atoll calls
5.
l
selected exchange
codes (charged)
l
local calls
l
international calls
atoll calls
l
any calls other than
specific exchange codes
(charged) programmed
6.
l
local calls
l
international calls
atoll calls
l
local calls (charged)
7.
l
any calls other than
specific exchange
codes programmed
l
international calls
atoll calls
l
local calls (charged)
@selected exchange codes
I
I
8.
all calls
For service class 3, up to 20 area codes can be
selected for use in toll dialing. See “Area Code
Entry for Class 3” on page 3-22.
For service class 5, up to 20 exchange codes
(charged) can be selected for use in local dialing
(charged). See “Exchange Code Entry for
Class 5” on page 3-23.
For service class 7, up to 20 exchange codes
can be selected for no use in local dialing.
See “Exchange Code Entry for Class 7” on
page 3-24.
For an area that uses Area code type as the
exchange code, up to 20 exchange codes can be
selected for use in local dialing. See “Allowable
Exchange Code Selection” on page 3-21.
Programming
1. 0
Dial
(61) for day mode.
“Day Toll Restrct” will be displayed.
0 Dial (62)
for night mode.
_
“Nig Toll Restrct” will be displayed.
2. Press the NEXT button.
“Jack NO ? + ” will be displayed.
3. Press the NEXT button or dial the jack number
(01 through 32 ).
“#Ol : Class-l” will be displayed and “1” will
x
jack number
blink.
4. Press the service class number (1 through 8).
5. Press the MEMORY button.
The LCD will stop blinking.
6.
l
0
0
To advance to the next jack number,
press the NEXT button.
To return to the previous jack number,
press the PREV button.
To go to the desired jack number,
press the SELECT button and then dial the
jack number.
7. Repeat steps 4 to 6, to program the assignment
on the other jack numbers.
8. To return to the initial program mode,
press the END button.
Programming Table
See pages 7-25 and 7-26.
3-68