Filter
Top Products
PROGRAMMING
To activate this system, the requirements from telephone company and the customer must be programmed once
the Power Switch has been turned on.
1.
At extension connected to jack number 01: All system
programming changes’(example : system clear,
toll restriction, system speed dialing entry-..) are
done through extension connected to jack
.
number 01.
0 Extension connected to jack number 01 must
2. System Program Switch setting:
The System Program Switch located on the
KX-T123211 must be set to the “PITS”
(Proprietary Integrated Telephone System)
position while making program change. After
all programming changes are completed, return
the program switch to the “SET” position.
3. Overlay:
This overlay is used for programming the
system and the program function names are
inscribed on this card. Refer to page 3-2.
4. Before system programming, operate the
system clear to set to the default data of the
program. See page 3-78.
Set the System Program Switch of the
KX-T123211 to the “PITS” position.
System Clear:
0
1. Dial (99).
2.
3.
“System Clear” will be displayed.
Press the NEXT button.
Re’peat pressing the SELECT button until the
“Menu: All Para” is displayed.
4. Press the MEMORY button to clear system.
5. To return to the initial program mode, press the
END button.
0 The following parameters are preset as the default
data.
System parameters
CO parameters
Extension parameters
DSS parameters
Speed dial