Filter
Top Products
To remove an attendant 1 From the Main Menu prompt, enter 1.
console
2 At
Port = , enter the CSSPP for the attendant console
you’re removing.
3 At
Action = , enter 1.
4 At
Data = , enter 0.
You will see a warning message for each type of
association the attendant console has with another station,
for example, for personal lines or Night Service coverage.
To go on with the action, type c each time you see the
system message,
c for continue, any other key for abort.
You see the following display when the attendant console
is removed:
Action = 1 Data = 0.
Note When you remove an attendant console, any Display ID
associated with the attendant dial code will also be removed.
Assign a Direct Extension Selector Console(s)
By default, System 25 assigns a DXS console, associated with first attendant console, to the
second port on the first ATL circuit pack. Follow the procedures in this section if you want
to:
■
■
■
Assign a DXS console to the second attendant console
Move the DXS console to a port other than the default port
Remove a DXS console
To assign a DXS console
1 From the Main menu prompt, enter 1.
at the second attendant
position
2 At
Port = , enter the CSSPP for the second DXS console.
3 At
Action = , enter 1.
4 At
Data = , enter 1602.
To move the DXS console
1 From the Main menu prompt, enter 1.
to a port other than the
default port
2 At
Port = , enter the CSSPP for the DXS console you
want to move.
3 At
Action = , enter 1.
4 At
Data = ,
assignment.
9-4 Administering Attendant Equipment
enter 0 to remove the current DXS port
(continued)