Filter
Top Products
Removing a Trunk
To remove a trunk
1 From the Main menu prompt, enter 1.
2 At
Port = , enter the physical port you want to remove in
the form CSSPP.
3 At
Action = , enter 1.
4 At
Data = , enter 0.
Note When you remove a trunk, any Display ID associated
with the trunk is also removed.
Assigning Class of Service to DID Trunks
To assign class-of-service
1 From the Main menu prompt, enter 1.
to a DID trunk
2 At
Port = , enter the physical port to which you want to
assign class of service.
3 At
Action = , enter 3.
4 At
Data = , enter the class-of-service code which is a
number (1, 2, 3, or 4) equal to the number of digits the CO
sends over this trunk. The default is 3.
Assigning Class of Service to All Other Trunks
To assign class of service
Note This section assumes that your trunks and their trunk
to all other trunks
numbers have been assigned.
1 From the Main menu prompt, enter 1.
2 At
Port = , enter the physical port to which you want to
assign class of service in the form CSSPP.
3 At
Action = , enter 3.
4 At
Data = , enter the trunk class of service code from the
next table. The default is 8. For dial-in tie trunks, only
codes 0-7 are valid.
Administering Trunks 5-3