Filter
Top Products
Administering Voice Stations
■
Assign voice terminals
■ Remove voice terminals
■ Assign and change station dial codes
■ Assign class of service
Using the Port and PDC Menus: Class-of-service options for single-line and multiline voice
terminals can be administered from either the PDC menu (Main Menu item 2) or from the
Port menu (Main Menu item 1). This makes it convenient for you to administer a station
based on the information you have. If you know the station PDC, use Menu 2; if you know
the station location (CSSPP) but not the PDC, use Menu 1.
Adding a Voice Station
You cannot add a voice terminal to a port where a station already exists. You must first
remove the existing station, then add the new station.
See the procedure entitled Removing a
Station.
To add a voice terminal
1 At the Main Menu prompt, enter 1.
[AG]
2 At Port = , enter the carrier/slot/port (CSSPP) for the
voice terminal you’re adding. For example, enter 10608 if
you want to add a voice terminal to port eight, slot six, in
carrier one.
If the port is available, you see the following message:
Port not translated
3 At Action = , enter 1.
4 At
Data = , enter the code for the voice terminal type
you’re adding. Table 7-1 shows the code associated with
each terminal type.
Note The only way to change an existing terminal type is
to remove and reinstall the station.
5 Next, assign a Personal Dial Code (PDC):
You see the prompt,
Action = 2.
At Data = , enter the PDC for this station. The valid
range is 1-9999.
6 To administer class of service for this voice terminal, see
Assigning Class of Service Options in this chapter.
Administering Voice Stations 7-1