Filter
Top Products
To troubleshoot
4 Type c.
The line now reads:
Save/Restore: Action = 3 Data = 1
The tape unit automatically starts the Restore procedure at
this point and stops when the restoration is complete.
If the restoration is successful, the SAT displays:
INITIATED WARM START
Following this procedure, the system automatically “warm
starts” to initialize the system’s ports with the options read
into the system.
5 Rewind the tape.
6 Store the tape in a safe place.
If the restoration is not successful, the SAT displays:
RESTORE FAILED
1
2
3
Rewind the tape and perform the restoration procedure
again. If the restoration fails a second time, get a blank
tape. Using this tape, perform the Save and Verify
procedures on the system’s current translations. Then,
perform the Restore procedure using this test tape.
If the restoration is successful using the test tape, your
current system translation tape could be damaged.
Perform the Restore procedure using a previous backup
tape, or contact your AT&T service representative.
If this restoration is not successful, do not use your backup
system translation tape. (Your digital tape unit may be
malfunctioning.
If that is the case, it could destroy the
backup tape as well.) Contact your AT&T service
representative.
Administering Tape Save/Restore Operations
13-5