Filter
Top Products
Paging (Associated with Auxiliary Trunk Port)
You can assign Paging to up to three zones.
Each paging zone must be assigned to a
separate port. Follow the procedure below to assign an access code and dial restriction to
each zone. If, in addition, you want to assign one access code to all zones, follow the
procedure below entitled “To assign an All-Zone access code.”
To assign a paging zone
1 Type t and at
Port = , enter the port number for the
access code [AG]
paging zone you’re administering
2 At
Action = , enter 1.
3 At
Data = , enter
■
1301 for Zone 1
■
1302 for Zone 2
■
1303 for Zone 3
4 You see the prompt
Action = 2.
5 At Data = , enter an access code (PDC) for this zone, or
0 for none.
6 Type a and at
Action = , enter 1 to dial restrict the
zone, or 0 not to.
To assign an
All-Zone 1 At
Action = , enter 3.
access code (if more than
2 At
Data = , enter a PDC for All-Zone access, or 0 for
one zone)
none.
Note The system automatically copies this value to all
paging zones.
6-2
Administering Auxiliary Equipment