Filter
Top Products
To move a data station to
1 From the Main Menu prompt, enter 2.
a new port
2 At
PDC = , enter the DDC of the station you want to
move.
3 At
Action = , enter 0.
The system displays the station’s present port assignment
at
Data = CSSPP
4 Type d, and at
Data = , enter the new port assignment
(CSSPP).
Assigning Class-of-Service
Options
This section describes the class-of-service options — the calling restrictions and features — you
can administer for data stations.
When assigning class-of-service options to a STARLAN CP, data port type code 1802, the
default values are relevant for the first installed port on the board. Unless otherwise noted,
values assigned to these action items on any of the four ports will be copied to all four ports
on the STARLAN CP. Therefore, default values listed below may not apply to a STARLAN
CP port, if you have previously changed that value for any port on the board.
To assign class of service
1 From the Main Menu prompt, enter 2.
to a data terminal
2 At
PDC = , enter the DDC of the terminal to which you
want to assign class of service.
Note If you are administering a STARLAN CP, the DDC you
assign to the first port will not be copied to the other ports on
the board. You will need to administer each port separately
for this action.
Assign Calling Restrictions
To restrict access to
1 At
Action = , enter 3.
Central Office trunk pool
2 At
Data = , enter 1 for yes or 0 for no. The default is 0.
8-4 Administering Data Line and STARLAN CP Ports