Filter
Top Products
Direct Extension Selector (DXS) Console System 25 assigns by default a selector (DXS)
console, associated with the first attendant console, to the second ATL port in the system.
Therefore, if you do not have a DXS console, you need to remove the default assignments
before you can reassign this port.
Assign a Switched Loop Attendant Console
To replace the default
1
DTAC with a SLAC
2
3
4
5
6
7
8
From the Main Menu prompt, enter 1.
At
Port = , enter the default port assignment for the
attendant console (CSSPP).
At
Action = , enter 1.
At
Data = , enter 0.
You will see several warning messages for feature
associations the attendant console has with other stations.
Each message ends with
c to continue, any other key to
abort.
Type c for each of these until you see the
message,
Action = 1 Data = 0
Type d and at Data = , enter 310.
Now reenter the attendant console PDC (since the default
PDC [200] was removed in step 5 above).
Type a and at
Action = , enter 2.
At
Data = , enter the PDC for the attendant.
Assign a Second Attendant Console
To assign a second
1 From the Main menu, enter 1.
attendant console (DTAC
2 At
Port = , enter the CSSPP for the second attendant
or SLAC; same type as
the first console) [AG]
console.
3 At
Action = , enter 1.
4 At
Data = , enter
■
309 for a DTAC
■
310 for a SLAC
5 You see the prompt,
Action = 2.
6 At Data = , enter the PDC for the second attendant
console.
9-2 Administering Attendant Equipment