Filter
Top Products
Miscellaneous System Options
From the Main menu prompt, enter 4, then set the following
system options:
To block
maintenance 1 At
Action = , enter 70.
busy of Ground Start
trunks
2 At
Data = , enter 0 for no or 1 for yes.
The default is 0@.
To assign the Central
Note This code cannot be changed after any trunks have been
Office trunk pool access assigned with this facility access code.
code
1 At
Action = , enter 71.
2 At
Data = , enter the CO trunk access code. The default
is 100, 101, or 102, depending on the trunk type.
To set the number of DID
1 At
Action = , enter 72.
digits used to match
against station PDCs
2 At
Data = , enter a number between 2 and 4.
The default is 3.
Expert Mode Prompt
To change the expert
1 From the Main menu prompt, enter 4.
mode prompt
2 At
Action = , enter 74.
3 At
Data = , enter the new prompt (nine or fewer printable
characters). The default is “Command:”.
@ Strongly recommended this value be used.
4-6 Administering System-Wide Options