Filter
Top Products
UFDATE 3-3
3.2
USING UPDATE
llte Option Control Chip (OCC) contains the features the lixhiba VP System is equippfxl with.
You cannot enter the
UPDATE
program if the OCC is not installed or if the OCC is generating
hardware errors Refer to tbehzshhtbn and M&me manual -
HARDWARE,
O$ion
&ntmI Ch@ for
more information.
m
n
Getting Ready
Refer tqthe khdladon and M&we manual - lNsI4UATION for instructions on
connect& the terminal. Refer to the UNDER!XANDlNG CONFIGURATION chapter,
hsuring Security section, for information on entering and cbnging the password.
Entering UPDATE
To enter
LPDATE,
at the @ prompt type:
UPpq
+
TBe terminal displays the following message:
l3e dot (.) prompt indicates the UPDATE is ready for a command.
UPDATE
does not work when an installation is inamplete. If you enter
UF’DATE
after an
installation has been suspended, the system prompts that an instalbtion is in progress. You
must finish the installation before you update the information. (Qpe IN at the @ prompt.)
Exiting UPDATE
Exiting saves the changes to the hard disk. Tb exit
UF’DATE
at any time, at the dot (.) prompt
9P=
YE [K]
UPDATE
displays: