Filter
Top Products
40 DESTINATION IS AN IVR SYSTEM (lnteradive Voice Response)
This attribute is assigned to a maiIbax that transfers the caller to tbe IVR System
extension number. Not applicable to Tbshiba VP Syskms.
41
MAY MOVE FORWARD OR BACKWARD DURING GREEIING
AllowsacallertousetheForwardandBacbard features wNe listening to a
greeting from a mailbox with this attribute. During the greeting. the caller must
entera~toachatethisfeahue.
This feature is designed to be used with spec%c applications. An aample is
recording long meetings so other employees may J&ten at a convenient time. When
this attibute is assigned, a “Quick Message” (IntraMessaging feature) can not be
sent while listening to the greeting.
After the
q
is entered, the prompt says, Yirfening ispoured
To back up, press two,
to go ahead press four.” If the caller does nothing after entering the
q
key, the
prompt says, “Li.Qening is pawed. To co&we, prets stm, to backup, press two, to go
o.hed,pnxs four” If the mailba does not have this attribute and a caller presses
q
, the Xxhiba VP System offers to record a “Quick Message.” The amount of
time the Toshba VP System moves forward and is&ward is defimed in System
Parameters % and 97. The default to move forward is l20 seconds, and to move‘
backwa& 60 seconds. Refer to the F&we Dex+zkwz manual -
CUSTOMEATION.
42
NEVER DO
ASAP
MESSAGE WAITING
43
When a message is left in a mailbox, the Toshiba VP System atte;hpts to call and
give notification. The default is set to call as soon as possible, unless the message
was left under a ‘ring-no-answef condition. With this attribute, Message Waiting
calls ‘5” minutes after the meSSage is left instead of as soon as possible. ‘Y’ is
defined in each mailbox by using the OFFIONS feature.
MAY RE-RECORD AFIER CALL MESSAGE
With this
attribute assigned to the COS of the mailbox called, after leaving~a
message for a no-answer or busy extension, or a mailbox with the greeting ON,
callers may re-record the entire message before sending it. This feature does not
allow e@tipg portions of a message.
-While recording, the caller must stop speaking for five seconds or enter a
q
to
activate this feature. The prompt says, “73rank you for
your masuge. To m-record
your mesage, press stm,
to send rhe mewge,
press pound. w
A
q
deletes the entire message and the prompt says,
‘Recording... (beep) ”
and
begins re-recording the message.
A
q
sends the message. The prompt says, “Message sent.
Please dial another
a-tension number, or dial zero for asistaace. ”