Filter
Top Products
89
NET. USE TRUNK RECONNECT CODES (NT Option)
lf
set to YES, the
Te
VP System uses System
Parameters !30,91,
and 92 for’
trunk reconnect. If not set or set to NO, the T&shiba VP System uses System
Parameters
I3
and
&,
values
are YES or
NO;
the default is NO.
90
NET RECONNECT CODE AFTER TRUNK ACCESS
(M
Option)
.+
De&es
the sequence of events
(eg.,
flash, F; expect dial tone, E; delay,
b;
etc)
the
lbshiba
VP
System
uses to reco~ect to the
caller on hold after accessing an
outgoing
trunk.
This is PBX dependent; there is not default.
91
NET! RECONNECT CODE
AFTER 3RD PARTY HUNG-UP (NT
Option)
D&mes the sequence of events (e.g., flash, F; expect dial tone, E; delay, D;
etc)
required to reconnect the caller on hold after being
disco~ected
from a remote
Toshiba
VP
System. The call is given
call
status for invalid mailbox numbers or
for results of a check procedure after the reconnect. This is PBX dependent;
there is no default.
92
-.
NET! COMPLETE TRANSFER TO TRUNK (NT Option)
.b
Defines how to complete a transfer to a trunk when placing a network call (e.g-
flash, F; expect dial tone, E; delay, D; or digits to dial). This is PBX dependent;
there is no default.
93
SEND ACCOUNT CODE TO PBX
DIGIT!3
(ICR Option)
[fl
If an extension number is assigned to a mailbox, it is sent to the PBX. If
no extension is defmed, the digits the caller entered are sent to the PBX.
94
RECONNECT AFTER ACCOUNT CODE DIGITS (ICR Option)
.