Toshiba VP 300S Answering Machine User Manual


 
- -
66
67
PLAY TIME STAMP
Whenamailbcntwiththisattributeiscalled,the?bshibaVPSystemspealrsthe
current date and time. This attribute is used prima&y for troubleshooting.
68
THIS PORT IS DTMF NTEGRATED (Adaptive Integration)
69
70
71
port COS, this attribute
allows direct access to VRvorkr When assigned to a
maiIM COS, this attribute allows access to VI%&3 through a ma&ox from any
PO*
THIS PORT IS FOR OUTCALLS ONLY, NO DlAL TONE
EXPECTED
This attribute is used for outcalls on PBXs that do not prwvide dial tone on initial
off-hook. A port with this attribute does not prcxcss incoming calls.
I&extension
number must not appear in a hunt group in the PBX
This attribute is used only with DTMF In-band Integration. Assign this attribute to
each port configured for DTMF In-band Integration. Refer to the Femure
Description manual - CUSTOMIZAlTON.
I
SPEAK DIGITS ENTERED TO CONFIRM MESSAGE ADDRESS
When addressing a message from a mailbox with COS Attribute 69 confiied, the
address is confirmed by being spoken back to the sender of the message.
* For messages addressed to a local mailbox, if no name is recorded, the prompt
“Mailbox” followed by the address digits is spoken.
0 For messages addressed to a network location, the prompt “Newark Mailbox”,
followed by the address digits is spoken.
a,r Whenamessageissenttoalocalmailboxwithanamerecorded,thenameis
spoken. Attribute 69 is not required.
MEASURE PBX TONES
When a mailbox with this attribute is called, the Toshiba VP System initiates the
call, stays on the line for ten tone changes, and then hangs up. This allows use of
the PRT command to determine the ringback/busylfast busy cadence for a
particular PBX.
TRANSCRlPTlON MAILBOX
When this attribute is assigned to the COS for the pilot of an extended mailbox,
messages are not recorded in the pilot mailbox, but are placed in the next available
member mailbox. For details, refer to
Fm Dtcscription -
CUSTOMIZATION,
Extended Mailbox.