Filter
Top Products
UPDATE 3-l
m
3.1
UNDERSTANDING UPDATE
Adds, changes, and deletions of information are aax)mplished *&rough the UPDATE program.
Use of UPDATE does not impact *em operation.
w UPDATE Commands
l *-
De following commands are used in the UPDATE program. Tb use the commands with each
configuration tabI% refer to the specific table section of this chapter.
LIST Use IJST to print or display information stored in the Toshiba
VP System database. This is the information you entered during
lNSTALL and the default values. To obtain a printout of the entire
&tabase, at the dot (.) prompt, enter
When listing the entire database, each COS is shown with only the
.SCHEDULE and INFORMATION Tables pertaining to that FOS.
iz$tsy
75 obtain a printout of any of the tables, at the dot (.) prompt, enters
L (TABLE NAME) (MODIFIER) -1
Press I=] at any time during a listing to stop $rA.ngw (A few
lines may print before printing stops.)
MODlPf
Use MODIFY to change informaGon in a table: correct a mistake
made during INSTALL, alter default information, change the system
date and time, and modify an existing entry. To MODIFY, at the dot
(.) promph enters
.
M (TABLE NAME) (MODIFIER) j==]
Use this wmmand to change the system date and time.
bl DATE