Filter
Top Products
the number of the mailbox to receive the copied messages. A copy of messages sent
toa~withthisattributeinitsCOScanbesenttoasingiemaiEbox,a .
Distribution List pilot number, or a Network mailbox. Refer to the Femurs
Des&p& manud - CUSTOMIZATION.
49
AUTO-DELETE A COPIED MESSAGE
Used in conjunction with Attribute 48. Automatically deletes the message in the
Original~andsendsittothemaiIbcarconfiguredintheprocessd~in
Attribute 48 Refer to the F’ Des+& manual - CUSTOMIXIION,
mm 50
STORE MESSAGES REDUNDANTLY
51
Used when two hard disk drives are installed and used for redundancy. Refer to
the Feanut Dtzmiption manual - HARD DISK REDUND,WCY.
RECORD SPECIAL PURPOSE GREElING
‘Ilis feature is designed to be used with qxcific applications An example is
recording long meetings so other employees may listen at a convenient time.
With this attribute assigned,
recording is more tolerant to silence, talkoff, and
inadvertent DlMF keypad entries or amtent in voice.
*
The maximum amount of silence before the prompt “Recora%tg irpatmd ake to
silence.. )) is controlled by System Parameter ll3. Normal silence before pause is 8
seconds. The maxim um for System Parameter ll3 is 4 minutes. If the silence limit
is reached, the greeting is retained in the maiIbcnz as it was recorded, up to the
point where silence began. Normal operation throws away a greqing ended by
maximum silence and keeps the previously stored greeting. Since DTMF detection
is disabled, recording is terminated only when
q q
is entered or the maximum
time Iimit for silence has been reached. Refer to the Fearure Dex+xion manual -
CUSTOMIZATION.
52
DYNAMIC CALL BLOCKING (Call BlocJcing) (Assign to PORT only)
AIlows blocking to be determined by the call blocking value of the first mailbox
dialed rather than the call blocking value of the port the call came in on. This frees
the port to answer any incoming call, regardless of the call blocking value of the
group being called.
This also enables CalI biocking to work with DID and E&M applications
rather than
blocking being applied on all ports so that DID/E&M caIls may be blccked.
The Dynamic CalI Blocking feature only works if the port call blocking value is 0
and the first mailbox being called has a calI blocking value other than 0. Any
subsequent calls
to mailboxes with
a call blocking value of 0 are placed.
53
NO DELAY BETWEEN EACH OFFSITE MESSAGE WAITING CALL
‘\
In
normal
operation,
the mailbox configuration parameter
determines the
amount
of
time
to
delay between placing Offsite Message Waiting calls (configured
by using