Filter
Top Products
4
i
Press ITCM
+k
# 7 4 6 % for base level.
1
1
FEATURE DESCRIPTION
ENTRY CODE AND PROMPTING DISPLAY REFERENCE RECORD
randem Attendant:
When this
1.
Dial 24. “TANDEM ATTN XXX
”
eature is enabled, a recall from an
2. Press
Al
to toggle between enable and disable
Jnanswered call transfer or timed hold
(LED On = Enable).
vecall
will ring at both attendant
-OR-
El
stations. When disabled, only the
Dial
1 to
enable. “TANDEM ATTN OFF”
attendant station which transferred
:he
call will ring.
Dial 2 to disable
(Al LED is on). “TANDEM ATTN ON
n
3. Dial
+#
for configuration mode.
Automatic Statlon Relocation:
Wtth
this feature, the system will
automatically recognize a particular
station should that station be
re-located to a different station port,
and supply the same COS
parameters as programmed for the
station at the original port.
NOTE: Refer fo station fe-assignment
1. Dial 27
“AUTO STA RELOCAT”
2. Press
Al
to toggle between enable and disable
(LED On
=
Enable)
-OR-
Dial
1
to Enable (Al LED On)
Dial 2 to Disable
3. Dial
+k
for configuration mode.
on page 4-51.
System Alarm Reportlng:
Special
codes which convey certain system
alarm conditions can be sent to a
station where they will show on the
LCD display.
NOTE: Also, choose the alarm
reporting stations. See page
4-35.
1. Dial 28. “ALARM REPORTS
”
2. Press
Al
to toggle between enable and disable.
(LED On = Enable)
-OR-
Dial
1
to enable.
Dial 2 to disable.
3. Dial
t
for configuration mode.
ALARM REPORT
ENABLE
DISABLE
DEFAULT
=
DISABLE
Press SPKR to end.
I