Filter
Top Products
System’Programming
IMI 66-083
SECTION 2
CLASS OF SERVICE PROGRAMMING
Class of service programming is usually performed by
the system installer. Class of service programming
procedures provide the means for programming all of
the system variables. The installer may elect to
program only the line attributes and allow the
remainder of the system variables to remain set to
their defautt values.
Perform class of service programming as shown
below.
o
Mark the desired selections in the
charts to record programming needs.
Enter the base level programming mode.
\
TYPICAL FEATURE PROGRAMMING SEQUENCE
\
Automatic
Hold For Intercom
feature enabled, pressing another
intercom button or line button while
already on an intercom call will
automaticalfy place this existing call on
hold.
10
-
57: Dial 10
r next station fea
Dial
~6
+
for configuration
)
Dial a feature code to select a programming
parameter.
A current program setting is indicated by a lighted
LED next to the applicable programming button.
When a toggle (ON/OFF) action is provided by a
single button, the lighted LED indicates when the
feature is active.
If a tone burst sounds three times during
programming, it denotes an erronous input.
Programming can be continued after an error
without ending and re-entering the programming
mode from base level..
@ Press
+k
to return to the most previous
programming level. Each press returns to the
next previous programming level.
Press SPKR to end procedure.
4-2