Filter
Top Products
, TAB 099
DigiTech System Software Enhancements
FEATURE
-
:ount
_ /des (cont.)
BENEFITS
VDT COS PRO-
To disable account codes,
l Enter7
To enable account code display for incoming calls,
l Enter8
To disable account code display for incoming calls,
l Enter9
To enable account codes display for outgoing calls,
l Enter 1 0
To disable account code display for outgoing calls,
. Enter 1 1
To set the account code message display time,
. Enter 1 2
.
Type in display time (l-20 seconds)
To set the maximum account code length,
. Enter 1 3
l
Type in account code length (3
-
16 digits) -- this number must be greater than or equal
to
the number of digits to verify
To set the number of accounf code digits to verify,
l Enter 1 4
l
Enter Y to prompt “Change Deletes All Verify Account Codes”
“Are you sure you want to do this (Y/N)
?,,
.
Enter account code length to verify (3
-
16 digits) -- this number must be less than or
equal to maximum account code length
To set emergency numbers (which will not require account codes for dialing),
l
Enter
1
5 (If there are already three emergency numbers stored, system will respond
“Table is Full,” in which case you will need to clear emergency numbers before
entering a new number -- see below)
l
Type in the emergency number (1
-
12 digits)
To clear previously stored emergency numbers,
l
Enter 1 6 (If there are no emergency numbers already stored, system will respond
“Table is Empty”)
9
Type in the emergency number to be cleared (1
-
12 digits)
7