Filter
Top Products
IMI 66-083
System
Operatjon
,
To tone call a DSS number,
l
Liit handset.
l
Press programmable button that is programmed for
desired station.
l
Press
ITCM.
Called telephone will ring.
NOTE: The lights (LEDs) adjacent to programmable
buttons indicate status of DSS telephones:
DARK indicates idle telephone, STEADY-ON
indicates telephone in use. FLASHING
indicates station is ringing (providing station
monitoring is enabled).
SECURE OFF-HOOK
VOICE ANNOUNCE (SOHVA)
To make a secure voice announcement to another
station that is off-hook or busy on a call,
If the calling station has a SOHVA originate button
programmed,
Lift handset.
Make intercom call and hear busy signal.
Press SOHVA button and hear SOHVA warning
tones (six quick tone bursts). If busy signal
continues, message cannot be delivered until called
party picks up handset; however, called station will
sound intercom ringing.
Deliver message.
Wait on line for reply.
If the calling station ddes not have a SOHVA button
programmed,
l Lii handset.
l
Make intercom call.
l
Hear SOHVA warning tones (six quick tone bursts).
If busy signal sounds, message cannot be delivered
until called party picks up handset; however, called
station will sound intercom ringing.
If calling from an LCD speakerphone,
l
Called station may send non-verbal message
response for display. As non-verbal response
message is displayed, calling station is
disconnected.
SPEED DIALING
To dial station speed dial numbers,
l
Press keypad digit 0
-
9 for desired personal speed
dial number.
OR-
If
on line listen to dial tone,
l
Press
HOLD
and then press desired keypad digit
o-9.
To dial system speed dial numbers,
0
Press
*.
l
Press keypad digits 01
-
99 for desired system
speed dial number.
-OR-
If on line listen to dial tone,
l
Press
HOLD
+#
and then press desired keypad
digits
01
-
99.
AUTOMATIC DIALING
To automatically dial numbers,
l
Press desired programmable button.
l
If desired programmable button is also programmed
for DSS (one-button intercom) calling.
l
Press HOLD
and then press desired programmable
button.
AUTOMATIC REDIALING
To activate automatic redial,
l
Press programmable button pre-programmed for
that purpose. ITCM light flutters while auto redial is
active.
l
Number will be dialed once a minute for ten minutes.
If called number Is busy,
l
Press auto redial programmable button to
immediately start the re-dial cycle.
If call is answered,
l
Take control by
liiing
handset. If control is not
taken, call will drop.
To cancel automatic redial,
l
Press auto redial button, lift and replace handset, or
press any station button.
NOTE: Any user originated station activity during
automatic redial
will
cancel the feature.
LAST NUMBER REDIAL
The last number previously dialed can be
automatically redialed with one-button or two-button
action.
l
Dial
#. (If on-line listening to dial tone, press
HOLD
then dial #.)
l
Listen for ringing or busy tone.
-
Ringing tone: When party answers, Iii handset.
-
Busy tone: Press MNTR (SPKR) to disconnect.
5-3