Filter
Top Products
i
TAB 099
DigiTech System Software Enhancements
FEATURE
,-
‘rer
ID (cont.)
BENEFITS
INSTALLATION NOTES
All Caller ID features require the delivery of Caller ID data to the input Port B. This port must be
configured to match the output of the Caller ID decoder device. The recommended configuration
is 9600 baud, with eight data bits and one stop bit. You can configure the port either from the
terminal Class of Service programming menus, or from station 10 or 12.
You have the option to provide Caller ID Distribution through the
W-232
port (Port B), over which
SMDR information is delivered. Caller ID Distribution is in the form of messages which specify
the Caller ID data for lines with incoming calls, and identify the stations answering such lines.
The data is in ASCII, formatted for use with PC-based application programs.
Figure 1 shows system configuration. Figure 2 illustrates the Printer-to-Port B connection.
To C. 0.
O-Pin
MALE
D-sub
IIIIIIII
~
Lines
to Common
Equipment
.
Cross Connects
.
Modular Cord
To 120V AC
Outlet
.
Customer-
Supplied
Cable
.
*
.
t
. . . l
.
87654321
PWR IN
OUT
Ports
RS-232 RS-232
I
CID08 Caller ID
Unit
Solder Cup Side
A
90
04
8@
03
7.
02
6.
DIgiTech
Common Equipmeni
Figure 1. System Configuration
--l--El
Caller ID Unit
RS-232 OUT
MALE
g-PIN, “D” -sub
I
;
TD
I
3
-7:
2
SG
SG
6
73
8
9
-
Common Equipment
RS-232 Data
Port
B
I
I
Printer PIN
Figure 2. Caller ID Unit and Printer to Common Equipment Through Data Port B
9