DigiTech System Software Enhancements
TAB 099
FEATURE
Account
Codes (cont.)
BENEFITS
VDT COS
PROGRB
1.
Enter COS programming
2.
Enter 1 for system COS programming
3.
Enter 8 for SMDA programming
4.
Enter 6 for account codes
To set account codes,
l
Enter
1
l
If the Verified Account Code Length is 3, the system will prompt you to “Enter Account
Codes (0
-
999)”
l
Type in valid account code(s), delimited by commas
If you enter fewer than three digits, the system will assume leading zeros
l
If the Veriiied Account Length is between 4 and 16, the system will respond “Table is
Full” (if all possible account codes are stored) or “Enter Account Code”
l
If the prompt “Enter Account Code” appears, type in only one valid account code
(the system will respond with “Command Accepted“ and will allow subsequent
account code entry)
l
If you type in more or less than the number of digits specified as the verified
account code length, the system will respond with
”
l
** Command Rejected
l
**
”
To clear account codes,
l Enter 2
l
If the Verified Account Code Length is 3, the system will prompt you to “Enter Account
Codes (0
-
999)
9
Type in valid account code(s) to be deleted, delimited by commas
If you enter fewer than three digits, the system will assume leading zeros
l
If the Verified Account Length is between 4 and
16?
the system will respond “Table is
Empty” (if there are no valid account codes in the
Itst)
or “Enter Account Code”
l
If the prompt “Enter Account Code” appears, type in only one valid account code
(the system will respond with “Command Accepted” and will allow immediate
subsequent account code entry)
l
If you type in more or less than the number of digits specified as the verified
account code length, the system will respond with
”
l
** Command Rejected
l
**
II
To enable optional account codes (with verification),
9
Enter3
To enable optional account codes (without verification),
l Enter4
To enable forced account codes (with verification),
. Enter 5
To enable forced account codes (without verification),
9
Enter 6