Filter
Top Products
DigiTech Software Enhancement
TAB080
FEATURE
BENEFIT
t
11
The first console (the one installed at the logic-paired port) extends the autodial buttons of the paired
Console
telephone by 32 and provides DSS/BLF coverage for station ports 10 through 41. Additionally, the
Feature
first console provides COS programmlng buttons Cl0 through
C41
when needed.
Refer to the
-continued
programming overlay that is included at the end of this publication.
The second console (the one installed at the programmed station port) provides DSS/BLF coverage
as follows:
l
On a Cl 632 with two CM408 expansion modules, the first 16 buttons are automatically assigned
(defautted) to station ports 42 through 57.
l
On a Cl
632
with one CM408 expansion module, the first 8 buttons are automatically assigned
(defaulted) to station ports 42 through 49.
l
On any other smaller station capacity system, all buttons are unassigned.
l
All 32 buttons on the second console are programmable for DSS and/or autodial use.
The second console provides COS programming buttons C42 through C57 when needed.
Refer to the programming overlay that is included at the end of this publication.
It is important to remember that when a second-console assignment is made or cleared, the console
button mapping and autodial values are reset to match the default values, or any previously
programmed ones, for the active feature. This means that when the second-console feature is
cleared,
the console installed at that port complements the telephone that is installed at the
logic-paired port instead of the one at the port set with the second-console programming. The
console buttons are automaticallv reassigned (defaulted) to stations 10 through 41 or to the maximum
station number on system. Figure 1 illusrates‘a typical dual console configuration.
A second console can be installed and programmed without
having a first console installed at a logic-paired port. The
button assignment is automatically defautted for a
c
second console but can be reprogrammed as
required. This configuration is convenient
for adding a console to an existing tele-
phone installation that already has
the logic-paired port occupied.
Do not use this configuration
for station ports 10 and 12
because the console buttons
will not be usable for
programming.
Typi&l DigiTech Telephone
(-Atgt8tbnPtilo)
Figure 1. Dual Console Wiring
Continued on next page. . .