Filter
Top Products
Installing and Configuring Telephony
Manager
2-24
Installing the PassageWay Service Provider
Software
This section describes how to install and configure the PassageWay Service
Provider. You can modify the PassageWay Service Provider configuration
information later by running the PassageWay Configurator.
NOTE:
If you have an earlier version of PassageWay Solution, you must exit
Connect or AT&TConnect (if it is running) before installing the new
PassageWay Service Provider.
To install the PassageWay Service Provider:
1. Start Windows (if it is not running already).
2. Shut down all applications running on your PC.
3. If you have an earlier version of PassageWay Solution applications
(for example, AT&TCall, AT&TConnect, or AT&TBuzz) installed
already, perform one of the following steps:
If you do not want to run the earlier version of PassageWay Solution
applications again, delete Connect or AT&TConnect from your
StartUp folder (if present).
If you want to run the earlier version of PassageWay Solution
applications again, leave Connect or AT&TConnect in your StartUp
folder (if present). Be sure to install the PassageWay Service
Provider in the directory that contains the PassageWay Solution
applications. If you install the PassageWay Service Provider in a
different directory, you must manually change the properties of
Connect or AT&TConnect in the StartUp folder so that it uses the
new Connect application. (See your Windows User’s Guide to
change the properties of a shortcut in the StartUp folder.)