Filter
Top Products
Installing and Configuring Telephony
Manager
2-23
To install the PassageWay adapter with telephone closet power:
1. Turn off your PC.
2. Unplug the line cord from your telephone.
3. Connect the line cord to the jack labeled “Line” on the PassageWay
adapter.
4. Check the LED on the top of the PassageWay adapter.
If the red LED is “on,” proceed to Step 5.
If the red LED is “off,” proceed to the section “PassageWay Adapter
LEDs” in Chapter 4.
If the red LED is “blinking,” proceed to the section “PassageWay
Adapter LEDs” in Chapter 4.
5. Determine the type of serial port (9 pin or 25 pin) you have on your
PC. If you have a 9-pin serial port, you will use the 9-pin to 9-pin
cable. If you have a 25-pin serial port, you will use the 9-pin to 25-pin
cable.
6. Connect one end of the appropriate serial cable to the 9-pin
connector on the PassageWay adapter.
7. Connect the other end of the serial cable to the serial (COM) port on
your PC.
8. Connect one end of the 7-foot, 4-pair, modular phone cord (D8W) to
the jack labeled “Phone” on the PassageWay adapter.
9. Connect the other end of the 7-foot, 4-pair, modular phone cord
(D8W) to the Line jack on your telephone.
10. Turn on your PC.
Proceed to “Installing the PassageWay Service Provider Software.”