Filter
Top Products
Installing and Configuring Telephony
Manager
2-19
Install the PassageWay Adapter with a Local
Power Supply
Perform the following steps if your telephone requires a local power supply.
You will need the 400B or 400B2 adapter, D6AP cable, and power supply
provided. Refer to Figure 2-1 while installing the PassageWay adapter. The
numbers in Figure 2-1 indicate the procedure steps.
To install the PassageWay adapter with a local power supply:
1. Turn off your PC.
2. Unplug the line cord from the wall jack.
3. Connect the line cord to the jack labeled “Phone” on the PassageWay
adapter.
4. Place the 400B or 400B2 adapter into the wall jack.
5. Connect one end of the 7-foot, 4-pair, modular phone cord (D8W) to
the jack labeled “Line” on the PassageWay adapter.
6. Connect the other end of the 7-foot, 4-pair, modular phone cord
(D8W) to the Line jack on the 400B or 400B2 adapter.
7. Determine the type of serial port (9 pin or 25 pin) you have on your
PC. If you have a 9-pin serial port, you will use the 9-pin to 9-pin
cable. If you have a 25-pin serial port, you will use the 9-pin to 25-pin
cable.
8. Connect one end of the appropriate serial cable to the 9-pin
connector on the PassageWay adapter.
9. Connect the other end of the serial cable to the serial (COM) port on
your PC.
10. Connect the D6AP power line to the power supply.
11. Connect the other end of the D6AP power line to the Power jack on
the 400B or 400B2 adapter.
12. Plug the power supply into an AC electrical outlet.