Filter
Top Products
Troubleshooting
4-25
Also insure that any RS-232 cables and adapters that you might be
using to connect the telephone or PassageWay adapter to your PC are
NOT null modem cables (a special type of cable), and that the total
length of the combined RS-232 cabling does not exceed about 40 feet
(the length should be as short as is convenient for your setup).
Insure your 8411 telephone or Callmaster VI telephone is receiving
power.
If your 8411 telephone or Callmaster VI telephone is not receiving
power, you should consult your account representative or authorized
dealer to obtain the proper wall power supply to power your telephone
or to correct any wiring problems that may be the cause.
Insure your PassageWay adapter is receiving power (as indicated by
the illumination of the power LED).
If you have verified that the PassageWay adapter is properly
connected to your telephone, yet the LED on the adapter is NOT
illuminated, your telephone system wiring may not support the remote
powering of adjuncts. If this is the case, you should consult you
account representative or authorized dealer to obtain the proper wall
supply to power your PassageWay adapter or to correct any wiring
problems that may be the cause.
Connect's software-based link test passes.
To assist you in diagnosing problems, Connect contains a built-in link
test procedure. This test can be run directly from the Communications
Error dialog box by choosing the Test button.
If the test procedure concludes successfully, Connect is
communicating properly with your 8411 telephone, Callmaster VI
telephone, or PassageWay adapter over the COM port you selected,
and you should select the Continue button on the Communications
Error dialog box to restore normal operation.
If, however, the test fails, an error number will be provided. Refer to the
following pages to interpret the error numbers and to find suggestions
for how to resolve the particular error you encountered.