Filter
Top Products
MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
Introduction
Page 1-4
Programming the System
■ Form 2c, System Numbering: Line/Trunk Jacks
■ Form 3a, Incoming Trunks: Remote Access
■ Form 3b, Incoming Trunks: DS1 Connectivity (100D Module)
■ Form 3d, Incoming Trunks: DID
Connecting Data Equipment
The following forms indicate the data equipment you will need to set up
data stations.
■ Data Form 1a, Modem Data Station
■ Data Form1b, 7500B Data Station
■ Data Form 2, Data Hunt Groups
Programming the System
If you have a system programming disk created with SPM or a
Translation memory card, you do not need to program the system.
Instead, you can use the disk or memory card to restore the system; see
Chapter 7, “Initializing and Testing the System,” for instructions. If you
did not receive a disk or a memory card and it is your responsibility to
program the system, see
System Programming
for instructions.
Upgrading the System
If you are upgrading to Release 6.1 from Release 6.0, 5.0, 4.2, 4.1, 3.1,
3.0, 2.1, 2.0, 1.0, 1.1, or from the MERLIN
®
II Communications System,
refer to Chapter 9, “Upgrading the System,” then Chapter 7, “Initializing
and Testing the System,” for upgrade instructions.