Filter
Top Products
MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
Initializing and Testing the System
Page 7-3
Setting the Time and Date
!Use SPM and the system programming disk to perform the Restore
procedure.
See
System Programming and Maintenance (SPM)
for instructions.
NOTE:
You must restore the system using either the system programming (or
backup) disk or memory card whenever a frigid start (System Erase)
occurs.
Setting the Time and Date
If the Control Unit Diagram indicates that you should set the time and
date, do so before you test the system.
Follow this procedure:
Menu:
6\V3URJ→6\VWHP→'DWH→'URS→Dial current date→(QWHU
See
System Programming
if you need additional instructions.
Testing the System
Once you have initialized the system, it is ready for system acceptance
testing. Perform the basic tests below to test trunks, telephones, and
features.
If any equipment is not working properly, see
Maintenance and
Troubleshooting
for troubleshooting instructions.
Testing MLX Telephones
This switch-based software test verifies that the LEDs, ringer, buttons,
switchhook, and B-channel operation for MLX telephones are working
correctly. You cannot run this test when the telephone is in