Filter
Top Products
MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
Installing the PC, CAT, or Printer
Page 5-18
Connecting a Printer to the Control Unit
■ 2012D transformer
■ 248B adapter
■ D8W cords
■ D6AP power cord
■ EIA-232-D cable
■ 4-pair plug-ended cable
To connect a printer 50 ft. (15.2 m) or further away from the control unit,
follow the steps below. See Figure 5–6.
!Plug the short end of a Z200A EMI cord into the SMDR jack on the
control unit.
!Plug the other end of the Z200A EMI cord into a 355AF adapter.
!Plug the female end of the 355AF adapter into one end of an EIA
crossover cable.
!Plug the other end of the EIA cable into the 25-pin male connector
of the Z3A2 ADU.
!
CAUTION:
If the printer is in a building outside the main building (control unit
location), you must install an ADU and an additional protector in
each building. The ADUs and protectors provide both the control
unit and the printer with additional protection against lightning,
inadvertent contact with power lines, and power currents induced
by nearby power lines. See the installation notes packaged with
the ADU for more information.
!Plug one end of a D8W cord into the WALL jack on the Z3A2 ADU.
!Plug the other end of the D8W cord into an ADU crossover cable.
!Plug the other end of the ADU crossover cable into one of the jacks
on a 400B2 power adapter.
!Plug one end of a D6AP cord into the other jack of the 400B2
adapter.