Filter
Top Products
MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
Upgrading the System
Page 9-19
Upgrading from the MERLIN II Communications System
!Replace old modules and add new modules as specified on the
Control Unit Diagram of Form 1, System Planning.
See “Installing the Control Unit” in Chapter 2 if you need instructions.
!Install the Release 4.0 processor module in the carrier.
See “Installing the Processor” in Chapter 2.
!Perform a frigid start (System Erase) to ensure that system
programming is returned to default values.
Use
6\VWHP(UDVH from the SPM Maintenance menu:
0DLQWHQDQFH→6ORW→00→'HPDQG7HVW→6\VWHP(UDVH (Line 5, left
button) twice→<HV
See
Maintenance and Troubleshooting
for more information on System
Erase.
!Program the system.
■ Restore the system programming from a system programming
disk or Translation Memory Card (Release 3.0 and later only), if
available.
See “Restoring from the System Programming Disk” or “Restoring
from the Translation Memory Card,” in Chapter 7.
■ If a disk or memory card is not available, see
System
Programming
for details on programming the system.
!If applicable, program new features.
See
System Programming
for detailed programming procedures.