Filter
Top Products
MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
Initializing and Testing the System
Page 7-8
Testing the System
a. Pick up the handset and wait for the dial tone.
b. If you pressed an SA button, dial the dial-out code.
c. Dial the destination telephone.
You should hear ringback on your telephone and ringing at the
destination telephone.
d. Have someone pick up the handset at the destination telephone;
verify that you have good two-way communication.
e. At both telephones, hang up.
!If the extension is toll-restricted, place a toll call.
You should hear a reorder tone.
Testing Ground-Start and Loop-Start Trunks
(Hybrid/PBX Systems Only)
To test the GS and LS outgoing and incoming trunks at a telephone,
follow the steps below:
!Dial
followed by the trunk ID number (01 through 80).
You should hear dial tone for a working trunk, a reorder tone for a DID
trunk or an invalid trunk number, or a busy tone if the trunk is in use.
NOTE:
Dialing
on a single-line telephone works only if the telephone
has a touch-tone dialpad and the trunk accepts touch-tone dialing.
!Repeat Step 1 for all outgoing trunks.
!Dial an incoming trunk on the system.
!Have someone answer the call at another telephone; verify that you
have good two-way communication.
!Repeat Steps 3 and 4 for all incoming trunks.
!Hang up to exit test mode.