Filter
Top Products
MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
Initializing and Testing the System
Page 7-4
Testing the System
programming, forced-idle, or maintenance mode. When an MLX
telephone is in test mode, the system considers it busy and therefore not
available for use.
If you hang up during any of these procedures, test mode ends
automatically.
Keep the following in mind when using the speakerphone:
■ If the Mute button is pressed before the Speaker button, the Mute
LED cannot be turned off; it winks.
■ The Mute and Speaker LEDs remain steady during test mode.
■ The pressing of the Mute button is processed within the
telephone.
■ When the telephone test is originated from the Speaker button,
every second press of the Mute button causes the Mute LED to
flash off momentarily. Also, both the Mute and Speaker LEDs may
occasionally remain on after disconnecting with the Speaker
button.
■ Press the fixed-feature buttons repeatedly to toggle the LEDs on
and off.
To test the basic features of an MLX telephone, follow the steps below:
!Pick up the handset of the telephone you are testing and push an
ICOM button in Key or Behind Switch mode or an SA button in
Hybrid/PBX mode.
!When you hear dial tone, dial
to activate test mode.
You should hear a steady test tone over the handset and a ring burst
over the speaker. The telephone’s red and green LEDs should be on.
!To test the line buttons, press any line button with two LEDs (red
and green).
The diagnostic tone should stop, and the LEDs for that button should go
off.