Filter
Top Products
Initializing and Testing the System
Page 7-1
Initializing the System
MERLIN LEGEND Communications System Release 6.1
Installation
Issue 1
August 1998
MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
7
Initializing and Testing the System 7
When you have finished installation, you are ready to initialize the
system as described in this chapter.
Initializing the System
To initialize a Release 6.1 system, use one of the following methods:
■ Restore from a 6.1 system programming disk or Translation
memory card.
■ Upgrade to Release 6.1 from Release 1.0, 1.1, 2.0, 2.1, 3.0, 3.1,
4.0, 4.1, 4.2, 5.0, or 6.0. See Chapter 9, “Upgrading the System.”
■ Use system programming forms and the procedures from one of
the guides listed in the next section, “Programming Guides.”
This section describes how to restore the system from the Translation
memory card or the system programming disk.
NOTE:
On initial installations, make sure you perform a System Erase
(frigid start), as described in
Maintenance and Troubleshooting,
either immediately before you restore from a disk or memory card
or before you program the system. Failure to perform the System
Erase (frigid start) can result in incorrect programming.