Filter
Top Products
MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
Installing Telephones and Adjuncts
Page 3-48
Assembling MLX Telephones
Assembling MLX Telephones
You will need to assemble an MLX telephone before connecting it to the
control unit. For all other telephones, skip to “Connecting Telephones to
the Control Unit on page 3-58
.”
Considerations
Review the following items before you begin the procedure:
■ MLX telephones are packed with the deskstand in the low
position. You can use the deskstand as is, raise it to a higher
angle, or remove it. To adjust or remove the stand, see Step 1 of
the following instructions. (The diagram on the bottom of the user
card tray also shows how to adjust the stand.)
■ You cannot wall-mount MLX-20L and MLX-28D telephones.
■ If you wish to wall-mount an MLX-5, MLX-5D, MLX-10, MLX-10D,
MLX-10DP, or MLX-16 DP telephone, you must remove the
deskstand first. (Wall-mounting an MLX-5D,MLX-10D,MLX-10DP,
or MLX-16DP telephone can make the display hard to read.)
■ A 630B Phonemount (not included) is also required to mount an
MLX-5, MLX-5D, MLX-10, MLX-10D, MLX-10DP, or MLX-16DP
telephone on the wall.
■ To connect an adjunct (such as an alert, modem, or fax machine)
to an MLX telephone, the telephone must have an MFM installed
in it. If you have not already done so, refer to “Installing
Multi-Function Modules,” on page 3-2
.