Filter
Top Products
MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
Installing Applications
Page 8-28
Installing a CTI Link
— A double-sided floppy disk drive (either 5.25-inch or
3.5-inch)
— A serial port assigned to COM1 or COM2. The serial port
can use either a DB-9 or DB-25 connector. If a DB-9
connector is used, a 9-pin to 25-pin adapter is also
required. The 9-pin side must be female.
■ Video monitor (monochrome or color)
■ D8W cord and 355AF adapter if the PC is within 50 ft. (15.2 m) of
the control unit. Distances of greater than 50 ft. (15.2 m) require
back-to-back ADUs.
See
System Programming and Maintenance (SPM)
for installation
instructions.
Installing a CTI Link
There are two procedures in this section: how to add a CTI link to the
MERLIN LEGEND Communications System—a
new installation
, and
how to get a CTI link working again after a link shutdown—a
link
reinstatement
.
New Installation
Considerations
In Release 5.0, the MERLIN LEGEND Communications System
supports one CTI link.
The system must be in Hybrid/PBX mode.
A telephone cannot be plugged into the CTI link port.