Filter
Top Products
MERLIN LEGEND Communications System Release 6.1
Installation
555-661-140
Issue 1
August 1998
Initializing and Testing the System
Page 7-7
Testing the System
Testing Telephones for Outside Dial Tone
To test for outside line dial tone, follow the steps below:
!Without lifting the handset, press one of the outside line buttons.
The red LED next to this button should turn on.
!Pick up the handset or press the Speaker button.
The green LED next to the line button should turn on and you should
hear a dial tone.
!Hang up and repeat Steps 1 and 2 for each line button on the
telephone.
Testing Analog Multiline and
Single-Line Telephones
To test the basic operation of analog multiline and single-line
telephones, follow the steps below:
!If you are testing a multiline telephone, press an ICOM or SA button.
!Pick up the handset and wait for dial tone.
!Dial the extension number of another working telephone.
You should hear ringback on your telephone and ringing at the called
telephone.
!At the called telephone, have someone pick up the handset; verify
that you have good two-way communication.
!At both telephones, hang up.
If you are testing a single-line telephone, this is the end of the procedure.
!If you are testing a multiline telephone, press an outside line or SA
button.
In Hybrid/PBX mode, make sure that the destination telephone has a
personal line or is a DLC operator.